Helmet Communication Systems

GEOCOMMS WATERPROOF COMMUNICATION SYSTEMS
 

Geocomms Helmet Accessories And Components

IMAGE GALLERY - Click on thumbnail to view larger picture

Choose an image to begin
Waterproof Communication Helmets

Helmets

A number of factors were considered when we began our design search for a helmet. Chief among these factors was safety. We required a lightweight unit to reduce neck stress and a snug fit to prevent bucket heading while user was in the water. Both of these objectives were reached with the use of Gath helmets.

Intercom Receiver

The Geocomms (GCI 201) Intercom Transceiver is a single channel intercom designed for stand alone use in the communication system for close proximity communications between RHIB crew members up to 100 metres or interface with a UHF/VHF Radio for longer distance communication.Geocomms Intercom Transceiver

Features built into the Transciever are PTT button, volume up/down, low battery and switch for toggling between UHF/VHF and intercom modes. The intercom is rated IP67. An example would be captain to crew, crew to captain and captain to base or base to captain.

The Geocomms (GCI 208) intercom Transceiver is an eight channel intercom designed for stand alone use in the communication system for close proximity communications up to 100 metres or interface with a UHF/VHF Radio for longer distance communication.

The eight channel Intercom allows close proximity vessels to operate on separate frequencies to crew yet also communicate to another vessel via the intercom within 100m on the same channel or UHF/VHF for longer distances where required. Features built into the eight Channel Intercom are the same as with the single channel with the inclusion of digital channel display for channel selection. The intercom is rated IP67. Inline Manual PTT - GC 504

Geocomms In Line PTT (GC 504) (Manual push to talk)

This item is designed as an optional piece of equipment that connect between
helmet and radio should the user wish to use PTT in the chest or hip position.
It is a small lightweight case with a red easy to find waterproof button
mounted on the face. The Manual PTT is rated IP67.Bone Microphone

Bone Microphone

The Bone Microphone is a specially designed conductor microphone that picks
up vibrations from the scull converts them into audible speech and transmits
them via Intercom or UHF/VHF radios to the receiving party. The Geocomms helmet use this system because the standard boom microphone picks up all surrounding noise and cannot successfully be waterproofed.Waterproof Speakers

Waterproof Speakers

The Geocomms Helmet use speakers with combined impedance of 16 OHMS that
are waterproof to IP68 rating they are mounted in the helmet close to the ear
channel for clear uninterrupted speech.Waterproof PTT Buttons

Waterproof PTT Buttons

These easy to find buttons are placed over the ear channel of the helmet exterior
and are water proof with an IP68 rating. They are 40cm in diameter and have a
soft clear defining click to enable a good feel when transmitting.

Down Lead and ConnectionDown Lead and Connection

The down lead on the typical helmet is hard wired to the helmet with a
Icom radio adapter fitted as standard. For use with the Intercom and
Manual PPT we have fitted IP67 rated connectors with screw caps
for protection.Remote With Finger PTT

Geocomms Remote with Finger PTT (GC 504)(push to talk)

This apparatus is designed primarily for military rifle use or in turn helmsman
allowing them to have control of the helm by both hands at all times. It fits
onto the operators finger and runs via an infrared system to operate UHF/VHF
radio or Intercom depending whether you use one or two button versions of
the PTT, operation is by the operators thumb pressing on the button allowing
transmission of either radio or intercom.

Geocomms Standard Headsets (GCHS 603)Geocomms Headsets

The headset was specifically designed for use in extreme noisy environments,
we use a Bilsom Leightning L1 Head set fitted with the Geocomms
Communication system similar to the typical helmet. The head set is
manufactured to Class B NRR 25 and is IP68 rated.

Summary of Helmet Components

What sets our systems apart from others is simplicity of design. It is impossible to hook our systems up wrong. Our components are built with the user in mind. Systems can be connected and disconnected on the fly. Have a view of the "Configurations page for the various ways of utilizing our components with different setups.

Related Links:

Helmet Configurations    Helmet Specifications     Helmet Applications    Retro Fitting